09
2021
-
11
The standard of measuring whether the mold processing is qualified
For manufacturers specializing in mold processing, whether the finished mold is standard and qualified will directly affect the production quality of subsequent products. Therefore, for some enterprises that need to use molds for industrial production, when purchasing molds, it is important to pay attention to whether they meet the production quality, whether they can meet the subsequent application needs and other aspects of the examination.
For manufacturers specializing in mold processing, whether the finished mold is standard and qualified will directly affect the production quality of subsequent products. Therefore, for some enterprises that need to use molds for industrial production, when purchasing molds, it is important to pay attention to whether they meet the production quality, whether they can meet the subsequent application needs and other aspects of the examination.
In the selection of mold, can be measured from the following aspects of a mold is up to standard
1. Accuracy. Whether it is a plastic mold or plastic mold processing, its precision and structural standard in the production process, are 2 to 4 levels higher than the actual precision of the workpiece to be produced. Only with the help of this type of mold produced products, more in line with the actual production needs.
2、Mould service life. Mold processing factory produced by the mold, because in the subsequent production and processing of products to be used repeatedly. If its own quality is poor, a short time damage or lead to the production of product quality failure will be higher probability of occurrence, is not conducive to enterprise production costs we save. So for the mold can use the years of the problem, the requirements will be more high.
3, look at the cycle of mold manufacturing. Mold production and processing cycle length, will directly affect the follow-up of the corresponding product production and processing speed. Enterprises in the choice of mold processing factory cooperation, to pay attention to its mold production and processing time to do a good job of considering the work, if the cycle is too long, it is likely to affect the use of the subsequent product replacement, affecting the normal production of enterprise products.
In the selection of mold, in addition to pay attention to the above aspects of the problem, but also pay attention to the cost of mold production and processing. If the whole mold production cost is high, it will directly affect the economic efficiency of the enterprise, and it is not a good choice for the enterprise.
Related news